UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 118 / 136

118
15. Seal the housings of the gearbox, transfer box, front and
rear axles by wrapping the safety valves of these aggregates with
the insulating tape.
16. Seal the clearance between the backing plates and the
brake drums with oiled paper.
17. Protect the tires and other rubber parts from direct sunlight.
18. Put metal or wooden props under the axles so that the
wheels are raised above the floor or the ground.
Unload the leaf-springs and springs, by putting wooden struts
between the frame and the axles.
The preserved vehicle should be located in a clean ventilated
room with a relative humidity of 40-70 % and temperature not
less than +5°C.
Do not keep chemically aggressive substances (acids, alkali,
etc.) in the same room with the vehicle.
Maintenance of a stored vehicle
Carry out the maintenance of the vehicle every two months.
Proceed as follows:
1. Carefully inspect the vehicle from the outside.
2. Unscrew the spark plugs (except for engine ZMZ-51432)
and shift in the first gear of the gearbox and the low gear of
the transfer case, then turn the crankshaft of the engine by
approximately 15 revolutions. Once a year, before turning the
crankshaft, lubricate the engine cylinders with 30-50 g of engine
oil.
3. Clean and paint corroded areas if any are detected.
4. Rotate the steering wheel from lock-to-lock position 2-3
times.
5. Check the service and parking brakes, the clutch, throttle
drive, and headlamp switches.
6. Check the working fluid level in the reservoirs of the brake
master cylinder. As required, top up to normal.
7. Check electrical equipment instruments.
8. Check the tools and accessories. Wipe and lubricate them
as required.
9. Check the condition of tires and other rubber parts.
10. Eliminate any detected defects during inspection.