UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 111 / 136

111
Fig. 9.46. Power fuse box:
1 — 2 — fuses (see the table)
Fig. 9.45. Relay and fuse box:
K1 — starter relay; K2 — main relay 2; K3 — main
relay 1; K4 — fuel heating relay; F1-F9 — fuses
(see the table)
When operating the vehicle and when checking the electric
equipment circuit, it is not permitted to use fuses not stipulated
by the design (see the table), and also it is not allowed short
circuit to the ground wire (to check the function of the circuits
"for spark").
Instrumentation and warning alarms
Periodically check the mounting of the devices, safety of
their contact couplings, and clean them from dirt and dust.
When removing electric sensors, isolate the wires to avoid a
short circuit. Use a hex socket wrench or a box wrench to remove
the temperature sensor and the coolant emergency temperature
sensor, without damaging their housings.
Check the fluid level in the cooling system of the radiator.
If the fluid level is low, the sensor may fail.
Once a year, check the accuracy of the coolant sensor reading.
For this, immerse the sensor in hot water after the hot water
temperature is measured by a control thermometer.