UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 87 / 136

87
The torque force of ball strut 8 (or housing 1 of the steering
knuckle, if the ball struts were not disconnected from the housing of
the axle shaft) in any direction, relative to the common axle shaft
of the pins, should be within the limits of 10-25 N•m (1.0-2.5
kgf•m) considering the removed O-rings 5, 6 and joint 7 of the
steering knuckle.
If the critical parameter is not reached, tighten the clamping
bushing once again by turning the wrench by 10-20° and tighten
nut 13 with the specified torque.
If the gap is not removed after the tightening of the threaded
bushing, the replacement of the liners of the pins units is needed.
You should contact the UAZ service station.
Fig. 9.26. Steering knuckle and wheel hub:
1 — steering knuckle housing; 2 — pin; 3 — pin liner; 4 — spring; 5 — outer
O-ring; 6 — inner O-ring; 7 — joint; 8 — ball strut; 9 — outer seal housing;
10 — clamping bushing; 11 — spacer; 12 — plate; 13 — nut