UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 38 / 136

38
3. Do not drive along rough roads (with deep mud, sand,
inclines, etc.).
4. A trailer may not be towed.
5. Do not change the oils in the engine and idol aggregates,
filled by the Manufacturer.
6. Monitor the temperature of the brake drums; in case of
strong heating, adjust the brakes.
7. Check the temperature of the wheel hubs; in case of strong
heating, loosen the bearings.
8. Check tension of the generator belt, cooling system pump
belt, power steering pump belt, fan belt and high-pressure fuel
pump belt, since during the run-in they are stretched to maximum.
9. Check the condition of all motor vehicle connections.
Carefully monitor the pipeline connections, eliminate oil, fuel,
and fluid leaks where revealed.
10. The motor vehicle technical maintenance length and
schedule during run-in is specified in the warranty and service
book.
Chapter 6. enGIne STArT AnD SHUTDoWn
ENGINE START
General
Prior to starting the engine, check for the presence of cooling
fluid in the cooling system, presence of fuel, and oil level in the
crankcase.
Move the shift lever to neutral position.
Attention! The ignition switch mechanism has an interlock,
allowing you to re-start the engine only after the key is returned
to position "0" (Fig. 3.5).
Release the ignition switch key immediately after the engine
starts running. The key returns to position "I" automatically (see
Fig. 3.5). Warm the engine up to the cooling fluid temperature
of at least 60°C.
Duration of continuous starter operation must not exceed
15 seconds. repeated turning on of the starter is allowed only
after a pause of least 1 minute, only three repeated turn ons are
allowed. If the engine has not started after this, you must detect
and eliminate the malfunction.
Do not start driving the motor vehicle with a cold engine.
It is strictly forbidden to speed up the engine warm-up process
through revving up the crankshaft rpm.