UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 116 / 136

116
for jacking up the wheel with jack shown on fig. 10.1, proceed
as follows:
1. Brake the vehicle with the parking brake, shift into the first
or reverse gear of the gearbox, making sure that the transfer case
gear lever is not in the neutral position. As required, put wedges
under the wheel, which is opposite to the jacked up wheel.
2. Install the jack on a level ground under the axle shaft
sleeve.
3. Unscrew the jack's internal screw 3 as high as the clearance
between the axle shaft sleeve and the ground permits.
4. Throw latch 5 over the jack to the left-hand side, relative
to the jack handle 6, so that latch projection enters the tooth
space of the ratchet wheel 7.
5. By pumping the tire iron inserted in the orifice of the jack
handle, lift the vehicle wheel to the required height.
6. For jacking down the wheel, throw the latch over the jack
to the right-hand side and by pumping the tire iron, deepen the
jack screws into the housing 1. After work is over, turn in the
outer 2 and inner 3 jack screws into the housing up to the stop.
for jacking up the wheel with jack as shown on fig. 10.2,
proceed as follows:
1. Brake the vehicle with the parking brake, shift into the first
or reverse gear of the gearbox, making sure that the transfer case
gear lever is not in the neutral position. As required, put wedges
under the wheel, which is opposite to the jacked up wheel.
2. Install the jack on a level ground under the axle shaft
sleeve.
3. Lift the vehicle wheel to the required height, rotating jack
hexagon 1 clockwise with the help of the wrench for the wheel
nuts.
4. To jack down the wheel, rotate hexagon 1 with the wrench
counterclockwise. After work is over, lay down the jack, completely
rotating the hexagon with the wrench.
Maintenance of jacks amounts to periodically cleaning it of
mud and lubricating its threaded parts.
Watch the condition of jack riveting couplings, its screws
and rods. Strain or damage of the screws and rods, loosening of
the riveting couplings is not allowed. Replace the jack in these
cases.