UAZ HUNTER 315195, Руководство по эксплуатации

Страница: 82 / 136

82
The switch of the clutch release pedal 9 is adjusted by nuts
10, providing a gap of 0.5 mm, indicated in the figure. After
the adjustment, tighten the nuts with torque 4-6 N•m (0.4-0.6
kgf•m).
The gearbox and the transfer case
During abrupt gear engagement/shift, a single knock may
occur in the gearbox.
During a sudden engagement of the front axle when driving,
a slight knock may occur in splines of the sleeve of the front
axle engagement.
During a sudden front axle de-clutching, a slight single knock
in the transfer case may occur.
When driving at a lower gear, the transmission noise is louder,
than when driving on the direct transfer of the transfer case.
Periodically check threaded couplings for proper fastening.
If a leak is detected, find out the reason and replace the
defective parts (spacers, collars).
To change the oil in aggregates, drain it immediately after
the vehicle stops and the aggregate is hot, unscrew the filler plug
first.
Fig. 9.20. Drive of master cylinder clutch release:
1 — tank cap; 2 — tank housing; 3 — master cylinder housing; 4 — protective
cap; 5 — push rod; 6 — nut; 7 — push rod sleeve; 8 — clutch releasing pedal;
9 — switch of clutch pedal; 10 — nuts; 11 — buffer