![UAZ HUNTER 315195 Скачать руководство пользователя страница 42](http://html1.mh-extra.com/html/uaz/hunter-315195/hunter-315195_operating-manual_3121034042.webp)
42
sharp and hard braking on a slippery road can result in the motor
vehicle skidding.
When driving the motor vehicle off the road (on sand, mud,
snow, etc.), on slippery roads, steep climbs (above 15°) and on
other rough road sections, do not overload the engine. In such
conditions, engage the front axle, and prior to motion, under
extremely severe conditions, also engage the speed reduction
gear in the transfer case. Engage the front axle, while the motor
vehicle is moving, and only engage the speed reduction gear in
the transfer case, after the motor vehicle comes to a complete
stop.
Steep climbs and downgrades.
When driving along the road
with steep climbs and downgrades, the driver must pay close
attention and act promptly. Determine the uphill gradient in
advance and engage the gear in the gearbox, which will ensure
the required rim pull to prevent changing of gears in climbing.
Steep climbs shall be passed at the speed reduction gear in the
transfer case and in the first gear in the gearbox. Climbs shall
be passed without stops and, if possible, without turns. Short
climbs with convenient approach and comparatively even road
surface shall be passed in acceleration without engagement of
the speed reduction gear in the transfer case, in the second or
third gear in the gearbox, depending on the uphill gradient. If the
climb cannot be passed for any reasons, take all the precautions
and go down slowly, having engaged the reverse gear. Go down
gradually, not allowing the motor vehicle to accelerate and not
releasing the clutch. For steep downgrades, involve the measures
ensuring safety when driving down. For a long downgrade (over
50 m), estimate its downhill gradient in advance and engage
in the gearbox and the transfer case the gears, in which the
motor vehicle would pass the climb of a similar gradient. Such
downgrades shall be passed using braking with the engine.
ATTenTIon!
Please remember that in case of frequent pumping
of the brake pedal (after the pedal is released, it is pressed again
immediately), the vacuum pump may not have enough time to
create the required negative pressure, causing the braking capacity
to decrease, and it will be necessary to apply an increased force to
the brake pedal.
It is prohibited
to pass a downgrade with a disengaged gear in
the gearbox or the transfer case, or with the clutch disengaged.
Содержание HUNTER 315195
