TV One C2-5000 Series, Руководство по эксплуатации

Страница: 49 / 116

C2-5000 Series Universal Scaler Operation Manual
49
13.0 ADJUST SCALER PARAMETERS SUB MENU
Sub menu…
Adjust Scaler parameters
Much of the work being done by the CORIO2 Scaler engine is controlled from the
Adjust Scaler Parameters Sub menu––the next in the series of Sub menus we
will investigate.
Pressing the Menu Select knob while on the Adjust Scaler Parameters screen
will take you to the first in a series of adjustment screens. Some you will
recognize from this manual’s Quick Start section. In fact, the first screen in this
sub menu is one you’ll recognize:
13.1 Zoom Level Adjust
Adjust Scaler Parameters
Zoom Level % [ 100%]
Once the above screen is display, pressing the knob again causes the brackets
to begin flashing. Rotate the Menu Select knob to the right to zoom the image up
to 1000%. Press the knob once to load the value into temporary memory. Press
and hold until you hear the ‘Beep’ to permanently enter the zoom parameter into
memory.
Enlarging the center of the image is nice but what if you are interested in
something other than the middle of a picture? Fortunately, there are adjustments
available that allow you to pan the image both horizontally and vertically.
After you have selected and saved the zoom percentage, rotate the Menu Select
knob one detent to the right. The following screen will appear:
Adjust Scaler Parameters
H/V zoom pan % [ 50] 50
Pressing the knob will cause the brackets surrounding the left number to begin
flashing. Rotating the knob will cause a horizontal movement of the image with a
Clockwise rotation causing the image to move to the left and a Counter-clockwise
rotation causing a movement to the right. When you have reached the desired
position horizontally, press the knob to load the result into temporary memory.
Next, move the brackets over to the right hand number by rotating the knob one
detent to the right and pressing the knob. The brackets will begin to flash again
and you can make the vertical adjustment so as to place the image at exactly the
desired position. Press the knob to load that value into temporary memory. Press
and hold the Menu Select knob until you hear a ‘Beep’, so you don’t lose the