TV One C2-5000 Series, Руководство по эксплуатации

Страница: 41 / 116

C2-5000 Series Universal Scaler Operation Manual
41
the Menu Select knob Clockwise and Counter-clockwise will move the image
vertically and again, if you press the knob, the brackets will cease to flash.
NOTE
: Any time you make an adjustment to a parameter, you have only written
the value to a volatile memory that will be lost should you unplug the Scaler. If
you want to make any adjustment permanent, you must press and hold the Menu
Select knob for a few seconds (until the Scaler emits a ‘beep’). Each time you
take this action, all data stored in all of the temporary memories are written to
non-volatile memory.
12.3 BR Size Adjustment (RGB, CV, YC, SDI)
Program Source [RGB1]
BR size adj. [ -12] [ 0]
After setting the image position, move to the screen that allows adjustments to
the size of the image. You’ll be setting the position of the Bottom, Right pixel.
Although you can zoom and shrink the image using the powerful Corio2
capability, these adjustments are used to set the size of the image before any
changes are artificially made using zoom or shrink. You’ve set the position of the
first pixel in the previous adjustments and now you will want make certain the
image completely fills the screen without over expanding it in either direction.
Pressing the Menu Select knob once will cause the left hand brackets to begin
flashing. You can then adjust the knob Clockwise or Counter-clockwise and
expand or shorten the width of the image. Notice that the left side of the image
stays locked where you positioned it with the TL Position Adjustment but the
image can be adjusted to fill the screen horizontally. Press the knob again and
the value is stored in temporary memory, the left-hand brackets cease their
flashing and the right hand set of brackets begin to flash. You can now adjust the
image vertically to fill the screen. As with the Horizontal adjustment, the first pixel
stays locked (and with it the top part of the image) but you can expand or
contract the vertical component of the image by rotating the Menu Select knob.
As with the TL Adjustment, you must select the source you wish to adjust via the
input buttons.
12.4 Input Pixel Phase (RGB Only)
Program Source [RGB1]
Input pixel phase [ -12]
Although a pixel is a very small element of the total image, it’s possible for the
Scaler’s A to D converters to randomly sample the picture on the edge of the