ConnectMe Tunstall Vi+ Installation and Programming Manual
8
Step 2
– Testing/Commissioning
Ensure the home unit is programmed to the correct telephone numbers (see page
18), then press the red alarm button on the home unit and ensure it raises a call
through to the monitoring centre/personal recipient. Also remember to test the
personal radio trigger by pressing its red button and ensuring a call is raised. The
personal radio trigger test should be done at various points around the property to
ensure the radio range provides sufficient coverage for the user to raise an alarm call
using their personal radio trigger. Remember to also set the time on the home unit if
you are using features that rely upon the home unit’s clock. Also test any other radio
devices that are programmed to the unit e.g. Smoke detector
Step 3
– Adding personal triggers/telecare sensors
For more information on adding personal triggers, please see page 16 of this guide.
The programming section of this guide also provides further information.
Step 4
– Ready to use
Once successfully tested, the home unit is ready for use.
Wall mounting (quick)
Decide where you want to situate the home unit. Remember it should be within 2
metres of a mains power socket and the main telephone line socket. Then hold the
Tunstall Vi+ in a horizontal position and use the two wall mount markers (see
diagram below) to accurately mark the wall. Drill 2 holes 40 mm apart, firmly attach
screws (not supplied) leaving the screw heads protruding from the surface and then
locate the wall mounting points on the back of home unit with the screws.
NOTE:
The diagram above is for illustrative purposes only and should not be used as a measuring tool
i.e. it is not drawn to scale.
WALL
40mm
