ConnectMe Tunstall Vi+ Installation and Programming Manual
30
Unit ID number
The Vi+ sends a unit ID number to the alarm receiver when an alarm is sent. The
number identifies which Vi+ is sending the alarm. Unit ID number 1 must be
programmed into the Vi+ in order for an alarm to be sent. The unit ID number may be
the same for all monitoring centres and personal recipients. Using the keypad, the
Vi+ can be programmed with up to 4 unit IDs (10 ID numbers can be programmed
using the other programming methods) e.g. ID 1 can be used for local alarms to a
recipient in a facility and ID 2 can be used for calls to a monitoring centre.
The unit ID can be programmed into the Vi+ by pressing:
1-4
Unit ID (max 12 digits)
NOTE
: If no unit ID is linked to an alarm receiver, the first valid code will be used. The actual number of
digits sent to the alarm receiver depends upon the type of monitoring centre being used. Please contact
your monitoring centre for more information.
To erase
one
unit ID number, press:
1-4
To erase
all
unit ID numbers, press:
Pendants and telecare sensors
To erase
one
pendant/sensor, press:
then activate the pendant/sensor.
To erase
all
pendants/sensors, press:
Turning features on and off
The Vi+ units have a wide range of other features that can be turned simply on or off.
When these features are turned on they automatically use the default settings listed
on the next page. The Xs below relate to the feature number in the feature list (see
following page). Some features can also be configured in the required way, for more
information see the section ‘Features explained and configuring settings’ on page 23.
To turn a feature
ON
, press:
X X X
