ConnectMe Tunstall Vi+ Installation and Programming Manual
18
How to program via PC Connect programming software
Home units can be connected to a laptop/PC using a USB TAPIT. The computer
requires PC Connect software loaded onto it (this can be downloaded from
http://www.tunstall.com/solutions/lifeline-vi).
The software provides the ability to
access enhanced programming features that series telephone/remote PNC
programming does not provide access to.
The software includes detailed help files that explain all the features and how they
can be tailored to meet the needs of individual people.
USB TAPITs can be purchased using part number 51900/01.
How to program via PNC software
PNC6
Using PNC6.3 monitoring software the operator can use custom designed screens to
program the features of the home unit remotely.
PNC5
From PNC5, the programming screens will be the same as Tunstall Connect and
home units. Therefore some new features will not have programming
screens.
PNC3/4
Remote programming of the Tunstall Vi+ is not supported from PNC3 or 4.
How to program using a series telephone
Step 1
– Connect a telephone directly to the socket on the home unit labelled
.
Step 2
– Place the home unit in to
programming mode by pressing and holding
down the green cancel button until it bleeps
(approx. 5 seconds). The home unit
an
nounces ‘Programming mode’ and the red
alarm button flashes slowly.
Step 3
– Lift the handset of the telephone and enter the quick codes listed on the
following pages. Manual entry of parameters can also be completed via this method,
however this should only be used when advised by Tunstall.
How to program using the Installer Keypad
Step 1
– Connect the installer keypad to the AUX socket on the Tunstall
