ConnectMe Tunstall Vi+ Installation and Programming Manual
27
It is then possible to modify the content of a parameter, this can be edited using
and then re-programmed by entering
at the end of the sequence.
Use the left arrow key to move to a digit to change it, then use the right arrow to
scroll to the end and press * to save it.
Quickcodes
To program any of the quickcodes into the unit enter the 4 digit quickcode followed
by
key
e.g. 2050
will reset the unit to default settings.
Setting the Time and Date on the unit
It is possible to use the keypad to set the time and date on the unit, this is important
when using any alarms that require the time/date to be correct E.G. virtual property
exit sensor.
To set the time, on the keypad enter
HHMM(24hr format)
To set the date, on the keypad enter
DDMMYYYY
To check the time and date the unit can speak the time and date, enter
3020
on the keypad.
Setting the Ringing Volume
To set the volume on the unit clear the display on the keypad by pressing the
.
Press the
to decrease the volume or the
to increase the volume. Once you
have selected the correct volume level press the
key within 10 seconds to store
the value.
Programming alarm telephone numbers
It is possible to program the first 4 telephone numbers using the following sequence,
to program the remaining telephone numbers use the manual entry method.
Monitoring centre numbers
Monitoring centre numbers are programmed by pressing
To add:
1-4
Tel. No. (max 16 digits)
