ConnectMe Tunstall Vi+ Installation and Programming Manual
14
should contact your supplier as soon as possible in the event of low battery
indication.
Programming a telecare sensor to the home unit
Telecare sensors with plug and play functionality can be programmed to the home
unit using the following steps:
Step 1
– Press and hold down the green
cancel button until it bleeps (approx. 5
seconds). The home unit announces
‘Programming mode’ and the red alarm button
flashes slowly.
Step 2
– Press and hold down the green cancel button again until it bleeps (approx.
3 seconds). Release the cancel button, the home unit announces
‘Registration Mode’
and the red alarm button flashes rapidly.
Step 3
– Activate the sensor/trigger, the home unit will announce the trigger type to
confirm registration.
Step 4
– Press and release the green cancel button. The home unit will bleep
(programming mode exited).
Step 5
– Test the sensor/trigger by activating it and ensuring it raises an alarm call.
If you would like to know which telecare sensors are currently available, please
contact your supplier.
NOTE:
Whilst in Step 3 the following quick codes can be entered via the series telephone handset to configure
telecare sensors related to the intruder setup.
6003
Set last assigned trigger as a Zone 1 armer
6004
Set last assigned trigger to be a Bogus Caller
6005
Set last assigned trigger to be a Zone 1 and Zone 2 armer
6006
Set last assigned trigger to be Zone 1 and Zone 2 arm/disarmer
6008
Set last assigned trigger to start entry/exit tones on activation
6009
Set last assigned trigger to not start entry/exit tones on activation
Using the below quick code, the last assigned trigger can be given a location.
4zxx
Set the last registered trigger for zone and location
Must be done before exiting program
mode where z = 0 for zone 1 and 1 for
zone 2, xx = TT21 location code, see
table 1
Range Test
The home unit has a range test feature that enables you to test the range of personal
triggers without raising an alarm call. This is done by putting the home unit into
programming mode (press and hold down the green cancel button until it bleeps).
When in programming mode, press the required personal trigger if it is within range
the home unit will bleep and announce the trigger or telecare sensor type.
