Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 98 / 205

TRACKMASTER
August, 2006 FVX, TMX Series Service Manual
8-17
Running Deck Replacement TMX Series
Tools Required
1/4 inch Allen wrench or socket
3/16 inch Allen wrench or socket
1/2 Inch Wrench or socket with extension
Jack stand or block capable of supporting the weight of the rear of the treadmill
Approximate Time to Complete – 30 Minutes
1. Elevate treadmill to 12%.
2. Turn treadmill main power switch to the off position.
3. Unplug treadmill plug from the wall receptacle.
4. Allow treadmill to discharge for 3 minutes.
5. Slide the hood grommets up the center handrail approximately 2’.
6. Remove the three hood securing bolts on the lower front end of treadmill.
7. Slide hood up treadmill center rail and force past the grommets, allow hood to hang
from grommets.
8. Lift rear of the treadmill and place jack stands or block to support the rear of the
treadmill.
9. Use the 3/16 Allen wrench or socket to remove the button head Allen bolt securing
the left and right end caps from the rear of the treadmill.
10. See Running Belt Replacement TMX Series assembly drawing.
11. Remove the end caps and place to the side.
12. Use a 1/4 inch Allen wrench or socket to completely remove left and right tension
bolts from rear roller. When removing the tension bolts maintain equal tension on
the bolts to avoid stripping the threads on the tension bolt or roller.
13. Push rear roller forward as far as it will go.
14. Lift the edge of the running belt up, use 3/16 Allen wrench or socket and remove
the six flat head Allen screws which secure the running deck cross braces. There
are six screws total, three on the left side and three on the right side.
15. Push the deck to one side of the treadmill and from the other side lift the edge of the
deck up and out over the side rail.
16. The deck is now ready for maintenance, replacement or to be flipped.
17. Lift up the edge of the running belt and slide the deck onto the deck braces.
Replace the screws securing the deck to the deck braces and tighten. Verify the
guide for the deck is to the left during installation.
18. Tighten the cross brace securing bolts, use caution to avoid over tightening the
bolts.
19. Align the bolt holes on the rear roller with the access hole of the end caps. Start the
tensioning bolts on the rear roller but do not tighten.
20. Replace the left and right end caps and replace securing screws.
21. Adjust the tension of the running belt; see Chapter 4 for Running Belt Tension
Procedure.
22. Reinstall hood by reversing procedure.