Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 22 / 205

TRACKMASTER
August, 2006 FVX, TMX Series Service Manual
4-3
TMX425 Series Initial Setup and Assembly
Treadmills may be ordered broke down or fully assembled. If you have received one
broke down please follow the instructions below.
Tools required for assembly
1/4" Hex key
3/16” Hex key
1/4" Hex nut driver
1/2" wrench
1. Slide hood Grommets on to center rail (Approx. 2 ft. up), one each tube.
2.
Next install U-bolts on to motor pan, place nuts on loosely, do not tighten, just to hold in
place
3.
Slide hood on center rail and force up past Grommets to keep it from sliding down.
4.
Route wire through U-bolt if wiring present on center rail.
5.
Slide center rail down through U-bolts until rail slides into rubber base mounts.
CAUTION! Be sure that no wires are pinched when handrail is seated in lower
mounts or DAMAGE will occur!
6.
ALL hardware should be left loose to aid easy assembly!
7.
Install the outer rails by first routing wire through hole, provided your application has a
wire in the rail.
8.
Slide the outer rail over the bracket and start the four button Head Bolts with washers into
base of handrail.
9.
Add clamp to one bolt and route power cord with RS 232 cable thru it.
10.
Install tube connectors with tube spacer between inner and outer rails and secure with
5/16 x 3” socket head bolt with lock washer.
11.
After all hardware is in place tighten all bolts, U-bolts last. Be sure center handrail is
down, by firmly applying pressure to it when tightening it.
12.
Plug in wiring per illustration and lower cover.
13.
Secure cover with three ¼” hex head self-tapping machine screw in front.
14.
Adjust brackets assuring Velcro makes contact at rear of the cover.
15.
Slide Grommets down against the cover last.
16.
Add Warning Card assembly with chain, and plastic dome plugs.
17.
Install End Caps and End Cap Spacer, Use a 3/16 Allen wrench to secure end caps (see
illustration).