Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 88 / 205

TRACKMASTER
August, 2006 FVX, TMX Series Service Manual
8-7
38.
Slide the belt back on to the sprocket.
39.
Reinstall the four nuts on the underside of the motor pan but leave loose until the
belt is properly tensioned and tracked according to the drive belt tension and
adjustment section in this manual.
40.
Reroute the three yellow motor wires and attach them to the inverter using the
small flat blade electrical screwdriver. Note; T-1, T-2, & T-3 designation on the
wires and the designation where they hook at the inverter.
41.
Plug the speed sensor back in to the power supply relay board.
42.
After belt has been properly tensioned and tracked tighten down the adjustment
nuts and the retaining nuts on the bottom side of the treadmill, see Chapter 4 for
Drive Belt Adjustment Procedure.
43.
Replace the hood and its bolts and slide the hood grommets back in to place.
44.
After installation run the treadmill checking for excess vibration and noise from
the motor area.