Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 118 / 205

TRACKMASTER
August, 2006 FVX, TMX Series Service Manual
9-3
COMMAND PROTOCOL
The Trackmaster Serial Communications Protocol consists of two types of commands, which
are INPUT COMMANDS and STATUS REQUESTS. When a command is sent to the serial
port, it is decoded and executed. The corresponding acknowledgement is then transmitted via
the serial port. The controller transmits acknowledgments and data only in response to a
command.
A - INPUT COMMANDS
ASCII CODES
HEX DECIMAL
A0 160
- Start Belt - Communication Disconnect Stop Enabled (Note 1)
A1 161 - Start Belt - Communication Disconnect Stop Disabled (Note 2)
A2 162 - Stop Belt
A3 163 - Set speed to the next 4 bytes of ASCII data (Note 3)
A4 164 - Set Elevation to the next 4 bytes of ASCII data (Note 4)
A5 165 - Set Time to the next 4 bytes of ASCII data (Note 5)
A6 166 - Set Protocol to the next 2 bytes of ASCII data (Note 5)
A7 167 - Set Stage to the next 2 bytes of ASCII data (Note 5)
A8 168 - Reset Distance, Total Time, and Energy to 0 (Note 5)
A9 169 - Set Weight to the next 4 bytes of ASCII data (Note 5)
AA 170 - Auto Stop - Sets speed and elevation to minimum and stops belt.
AB 171 - Auto Cool Down - Sets speed and elevation to minimum.
AC 172 - Toggle Transmit Acknowledge Data Flag (Note 6)
B - INPUT COMMAND ACKNOWLEDGEMENT
ASCII CODES
HEX DECIMAL
B0 176
- Ack. Start Belt - Communication Disconnect Stop Enabled
B1 177 - Ack. Start Belt - Communication Disconnect Stop Disabled
B2 178 - Ack. Stop Belt
B3 179 - Ack. Set Speed
B4 180 - Ack. Set Elevation
B5 181 - Ack. Set Lap or Stage Time (Note 7)
B6 182 - Ack. Set Protocol (Note 7)
B7 183 - Ack. Set Stage (Note 7)
B8 184 - Ack. Reset Distance, Total Time, and Energy (Note 7)
B9 185 - Ack. Set Weight (Note 7)
BA 186 - Ack. Auto Stop
BB 187 - Ack. Auto Cool Down
BC 188 - Ack. Toggle Transmit Acknowledge Command Data Flag
BE 190 - Input Command Data Out of Range
BF 191 - Illegal command or command not recognized