Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 85 / 205

TRACKMASTER
8-4
FVX, TMX Series Service Manual August, 2006
22. With the insulators and Spacers still in place on the motor plate, set the new
motor on the plate and reinstall the four bolts with nuts. Make sure the spacers
and insulators all stay in place or the treadmill can become a shock hazard when
in operation.
23. Adjust the sensor to magnet gap to approximately 1/16”.
24. Set the motor assembly back down into the treadmills motor pan slots and reroute
the motor wires thru motor pan (See Illustration for proper part locations).
25. Slide the belt back on to the sprocket.
26. Reinstall the four nuts on the underside of the motor pan but leave loose until the
belt is properly tensioned and tracked according to the drive belt tension and
adjustment section in this manual.
27. Attach motor wires the inverter using the small flat blade electrical screwdriver.
Note; T-1, T-2, T-3, & Ground designation on the wires and the designation
where they hook at the inverter (See illustration proper wire location).
28. Plug the speed sensor back in to the power supply relay board.
29. After belt has been properly tensioned and tracked tighten down the adjustment
nuts and the retaining nuts on the bottom side of the treadmill, see Chapter 4 for
Drive Belt Adjustment Procedure.
30. Replace the hood and its bolts.
31. After installation run the treadmill checking for excess vibration and noise from
the motor area.