Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 73 / 205

TRACKMASTER
6-10
FVX, TMX Series Service Manual August, 2006
FVX325CP, TMX425CP Elevation Calibration Procedure
Tools Required
Tape Measure
1/4” Allen Wrench
Prior to performing the elevation calibration procedure, enter the programming mode and enter
the elevation calibration grade and elevation limits. To perform elevation calibration, place
the console in elevation calibration mode. A drawing and table are available to assist in
determining percentage of elevation.
1. Remove front rail end cap and bolt on TMX425 Series.
2. Enter Elevation Calibration mode. Observe message center window displays
Press Stop & Enter for GRD CAL.
3. Press the Stop and Enter keys simultaneously. Message center window display has
CAL GRADE.
4. Press the Start button. Speed window displays decline.
5. Once treadmill has reached minimum elevation, the display will change. The
incline window will display the first elevation set point ( 0.5 ) and the distance
window will display the elevation count from the elevation sensor ( 1000 ).
6. Use an incline meter, protractor or other measuring device to determine the degree
of elevation or use the procedure provided to measure the distance from the floor
to the bottom of the side rail.
7. Press the up incline button until a height of 0.5 % elevation is reached.
8. Press the start button, the incline window will display the second elevation set
point ( 5.0 )
9. Press the up incline button until a height of 5.0% elevation is reached.
10. Press the start button, the incline window will display the third elevation set point
( 10.0 )
11. Press the up incline button until a height of 10.0% elevation is reached.
12. Press the start button, the incline window will display the fourth elevation set point
( 15.0 )
13. Press the up incline button until a height of 15.0% elevation is reached.
14. Press the start button, the incline window will display the fifth elevation set point
( 20.0 )
15. Press the up incline button until a height of 20.0% elevation is reached.
16. Press the start button, the incline window will display the sixth and final elevation
set point ( 25.0 )
17. Press the up incline button until a height of 25.0% elevation is reached.
18. Press the start button, the treadmill will reset and return to the normal operating
mode.
19. Replace end cap and bolt on TMX425 Series.