Trackmaster FVX325, Руководство по обслуживанию на месте

Страница: 69 / 205

TRACKMASTER
6-6
FVX, TMX Series Service Manual August, 2006
19. If the angle reading is higher than 25%(14.1°). Take the following steps to
correct: (Refer to illustration FVX325, TMX425 Series elevation actuator
Adjustment.)
ƒ Remove actuator top cover.
ƒ Using a large (.375" wide) flat blade screw driver, rotate the lower switch
cam counterclockwise the proper amount to assure the treadmill will not
elevate past 25%.
ƒ Lower the value and raise it again to verify the treadmill dose not travel
past that point.
ƒ Return the box value to allow the treadmill to stop at 25% to complete the
grade calibration.
ƒ If the cam was turned to adjust the lower switch, the upper cam will need
to be reset to zero to allow the treadmill to park in the correct position.
ƒ This is achieved by turning the upper cam (by hand) clockwise back the
approximate amount the lower cam was turned.
ƒ Check tape measure reading and adjust upper cam to compensate for any
error.
ƒ Repeat steps 1 thru 9 until the correct values are achieved.
19. Return to 0 incline.
20. Hit disconnect button.
21. Replace end cap and bolt on TMX425 Series.
FVX325 Series Elevation Chart
Dim. Grade Inches MM
A 0% 3.04” [77.3mm]
B .5% 3.32” [84.3mm]
C 5% 5.62”
[142.8mm]
D 10% 8.42” [223.8mm]
E 15% 11.20” [284.5mm]
F 20% 13.48” [342.4mm]
G 25% 15.84” [402.4mm]