Total Control MP/16, Руководство оператора

Страница: 83 / 182

Link Security 4-5
Step 3—Enable Link Security
Link Security
AT Command:
Enable: S53.0=1
Disable S53.0=0
MIB Object: mdmLsSecurityEnable
Step 4—Activate Link Security
Link Security is not fully active until you store all settings to the
modem’s NVRAM and reset the modem. Before completing this
step,
verify your passwords to avoid the risk of being locked out of
your modem. If you are using AT commands, passwords may be
verified using the
ATI10
command.
Store to NVRAM
AT Command: &W
MIB object:
storeToNvram
TCM: Select the appropriate modem(s), and from the
Actions/Commands
dialog box, execute the
Store to NVRAM
command.
Software Reset
AT Command: Z
MIB Object:
softwareReset
TCM: Select the appropriate modem(s), and from the
Actions/Commands dialog box, execute the Software Reset
command.
Viewing Account Status
Link Security account status, including selected options and
passwords, can be viewed through TCM or other SNMP Manager
software. If you wish to use AT commands to view account status,
use the following command:
ATI10
If Local Access Protection is enabled, the ATI10 command cannot
be used unless the %S command has first been used to gain local
access to the Link Security account (See
Local Access Protection
in
Step 2 above).