Toro Multi Pro 41240, Руководство оператора

Страница: 18 / 96

2. Connect the 3-pin connector of the wire harness
of the machine for speed sensor into the
3-socket connector of the sprayer harness for
the speed sensor (
Figure 17 ).
8
Coupling the Sprayer Pump
No Parts Required
Procedure
•
For HD-series models with a manual transmission,
couple the PTO shaft to the transaxle PTO; refer
to the
Installation Instructions for the Multi Pro WM
Turf Sprayer Finishing Kit, Manual Workman Utility
Vehicle.
•
For HDX-Auto model—connect the hydraulic
motor hoses to the quick-disconnect fittings at the
high-flow hydraulic panel; refer to the
Installation
Instructions for the Multi Pro WM Turf Sprayer
Finishing Kit, Automatic Workman Utility Vehicle.
9
Installing the Control
Console to the Machine
Parts needed for this procedure:
1 Console mounting bracket
3 Flange locknut (5/16 inch)
3 Flange-head bolt (5/16 inch)
2 Plastic bushing
1 Control console
1 Spring-clip pin
1 Hand knob
Installing the Console Mounting
Bracket
Note:
On some Workman vehicles, the control mount
plate is attached to the dashboard at the same location
where the bracket for the optional hand throttle kit is
mounted. If the hand throttle kit is installed, you need
to remove the bracket of the hand throttle assembly
from the dashboard, align the control mount plate to
the dash, and install the hand throttle bracket on top
of the control mount plate. Refer to the Hand Throttle
Kit
Installation Instructions for directions on removing
and installing the hand throttle assembly.
1. Remove the 3 bolts and 3 nuts that secure the
lower-center portion of the dash panel to the
dash support bracket (
Figure 18 ).
Note:
Some older Workman machines may use
4 bolts and flange nuts.
Note:
Discard the bolts and nuts.
g028408
Figure 18
1. Bolt 5. Bushing (plastic)
2. Nut 6. Flange-head bolts (5/16 x
1 inch)
3. Cash panel (lower center
area) 7. Flange locknuts (5/16
inch)
4. Mounting bracket (control
console)
2. Align the holes in the mounting bracket for the
control console with the holes in the dash and
support bracket (
Figure 18 ).
3. Assemble the mounting bracket dash panel and
support bracket with the 3 flange-head bolts
(5/16 x 1 inch) and 3 flange locknuts (5/16 inch).
4. Torque the nuts and bolts to ( Figure 18 ).
18