Preparing the Machine for
Service
1.
Insert the pressure-sense tube into the
push-to-connect fitting until it is fully seated
(
).
g362136
Figure 133
1.
Push-to-connect fitting
2.
Pressure-gauge tube
2.
Close the spigot of the fresh-water tank.
3.
Add fuel to the fuel tank.
4.
Service the vehicle; refer to the
Operator’s
Manual
for your vehicle.
Removing the Sprayer and
Tank Skid
Lifting equipment capacity:
408 kg (900 lb)
DANGER
The sprayer tank assembly presents a stored
energy hazard. If not properly retained when
installing or removing the assembly, it can
move or fall and injure you or bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance whenever you
remove the retaining fasteners.
Preparing the Center Console
1.
Disconnect the battery cables from the battery;
refer to
6 Disconnecting the Battery (page 16)
.
2.
Separate the fuse block of the sprayer from the
fuse block of the machine and disconnect the
wiring between the 2 fuse blocks; refer to
Installing the Sprayer Fuse Block (page 20)
.
3.
Remove the wire harness from J-clips; refer
to
Routing the Rear Electrical Harness for the
Sprayer to the Control Console (page 19)
.
4.
Loosen the hand knob that is located below
the console and remove the hairpin; refer to
Installing the Control Console to the Machine
(page 19)
.
5.
Disconnect the terminals of the wires that
connect the fuse block for the sprayer with the
fuse block of the machine; refer to
the Sprayer Fuse Block (page 20)
.
6.
Separate the fuse block for the sprayer from the
fuse block for the machine; refer to
the Sprayer Fuse Block (page 20)
.
7.
Remove the console from the console-mounting
bracket at the dash of the machine and align the
pivot pin on the control console with the storage
bracket at the front tank strap (
); refer
to
Installing the Control Console to the Machine
(page 19)
.
g033615
Figure 134
1.
Control console
3.
Hairpin
2.
Storage bracket (front
sprayer-tank strap)
8.
Assemble the console to the bracket and secure
the pivot pin to the bracket with the hairpin
(
).
90
