Thermo Scientific Surveyor RI Plus, Руководство по оборудованию

Страница: 15 / 58

1
Introduction
Back Panel
Thermo Scientific Surveyor RI Plus Detector Hardware Manual 3
Back Panel
The power entry module, the Ethernet port, and the 8-pin interconnect receptacle are located
on the back panel of the RI detector as shown in
Figure 2 . The back panel also contains
terminals that allow you to connect a chart recorder or an integrator. See Table 1 for a
description of the 16 terminals on the back panel of the RI detector.
Figure 2. Back panel of RI detector
Table 1. Terminals on the back panel of the RI detector (Sheet 1 of 2)
Terminal No. Label Description
1 GND Ground terminal
2 +5V@150mA
3 NC
4 RUN
5 READY Signal out Ready
6 ZERO External Signal in (AutoZero)
7 GN Ground terminal
8 PURGE External Signal In (purge On)
9 RE Recorder out
10 RECORDER - Recorder out
ENET
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
PURGE GND ZERO READY RUN NC +5V @ 150mA GND NC CHASSIS GND INTEGRA
TOR -
-
INTEGRA
TOR +
NC CHASSIS GND RECORDER -
-
RE
355 River Oaks Parkway
San Jose, CA 95134 U.S.A.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause
undesired operation.
61010 - 1
CAUTION
Disconnect Input Power Before Opening Cover
Service by Qualified Personnel
220V T1.6AL 250V 100VA
110V T3.15AL 250V 100VA
FUSE
110V/220V 50/60HZ LINE
Ethernet
port 8-pin interconnect
receptacle
Fuse
holder
Power entry
module