Teradyne Z1800 Series, Руководство оператора

Страница: 98 / 118

3-5
Z1800-Series Operator’s Guide
2
Press the Vacuum Interface switch to pull the fixture on to the fixture receiver
interface.
3
Connect the vacuum hose(s) to the fixture hose fitting(s).
4
Set the fixture vacuum switches on as required.
5
Set the operator control panel for Tandem or Independent.
In Tandem mode, the Start and Cancel of either system affect both systems. In
Independent mode, the testers are completely independent except for the common
Power Control switch and a single Interface Vacuum switch which activates
whichever interface has a fixture installed.
6 Carefully load the board for system A, aligning the tooling holes on the board with
the tooling pins on the fixture. Then load the board for system B.
Load the Fixture and Board for the Z1860M, Z1850M, Z1840M
For instructions about loading the fixture, refer to the user manual for the unit you are
using.
Log In After you have loaded the fixture and board, make sure you follow all safety precautions
regarding power and setup before you apply power to the board. Safety precautions are
discussed in Chapter 1.
Important:
You must log in to both systems A and B for the Z1866.
The login procedure described below is the default procedure. Consult with your supervisor
to determine how your system is set up.
1 Go to the test program’s Main menu by typing 1
8xx
after the DOS prompt and
pressing Enter.
The Main menu appears on your screen with Files and Setup highlighted on the
menu bar, indicating that only those menus are available at this point.
2
Select Setup from the Main menu.
The Setup pull-down menu appears.
3
Select Login.
Files Edit Run Pgen Setup Utility Templates GFI Convert Setup
Path Data
Device & Channel Data
System Variables
Environment Variables
GFI Setup
Validate Configuration
Color Settings
Serial Port Setup
Login
Change Permissions
Change Passwords
Set Default Login
Save
Revert