Telecast CH3-MPS-95VD-2ST-304, Руководство пользователя

Страница: 68 / 86

Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver System User Guide – 110124V4JH
Page 66
To cycle between Base RX and Cam RX modes, push the Display Mode selector button quickly.
To enter Diagnostic mode, hold the Display Mode selector button for more than 5 seconds. Once in the
Diagnostic mode, a quick push of the selector button cycles through the various diagnostic sub-modes
described above.
The following table describes the expected readouts in each of the above Base Station display modes. By
following the sequence you can understand what the various readouts and four character abbreviations
mean for the system.
Display Mode
Typical
Readout
Base Station Digital Display Activity Explanation
(assumes after initial power up – see Page 66 for a description of the Power Up sequence)
BOPT: Base Station Optical Receive Signal Strength
BASE RX -9 Indicates that the Base Station received optical signal strength is -9 dBm.
BASE RX BOPT Indicates that the Display is showing Base Station optical signal strength.
BASE RX -9 Repeat of the Base Station optical signal strength in dBm.
BASE RX BOPT Repeat that the display is showing Base Station optical signal strength.
This display cycle repeats itself and depending on timing may start with
either BOPT or the strength measurement.
COPT: Camera Unit Optical Receive Signal Strength
CAM RX COPT Sequence starts with COPT to indicate Camera Unit optical signal strength.
CAM RX -9 Indicates that the signal strength from the Camera Unit is -9 dBm.
CAM RX COPT Repeat of the display indicating Camera Unit optical signal strength.
CAM RX -9 Repeat of the Camera Unit signal strength in dBm.
CAM RX COPT Repeat that the display is showing Optical link signal strength.
This display cycle repeats itself and depending on timing may start with
either OPT of the strength measurement – COPT does not reappear in the
repeating cycle.