Telecast CH3-MPS-95VD-2ST-304, Руководство пользователя

Страница: 69 / 86

Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver System User Guide – 110124V4JH
Page 67
Display Mode
Typical
Readout
Base Station Digital Display Activity Explanation
To enter Diagnostic mode, push and hold selector button for 5 seconds.
DIAGNOSTIC MODE Temperature (TEMP)
When first entering the Diagnostic mode, the DIAG display mode indicator
LED will blink – the first sub-mode is TEMP (Temperature). The DIAG LED
will glow
Green when the temperature is normal and Red when outside of
normal range.
DIAG/TEMP TEMP Indicates the display is in the TEMP sub-mode.
DIAG/TEMP PS The Power Supply (PS) temperature will be displayed.
DIAG/TEMP TEMP Repeats that the display is in the TEMP sub-mode.
DIAG/TEMP 37C Temperature display in Centigrade for Power Supply circuit board.
DIAG/TEMP BASE The Base Station main circuit board temperature will be displayed.
DIAG/TEMP TEMP Repeats that the display is in the TEMP sub-mode.
DIAG/TEMP 47C Temperature display in Centigrade for Base Station circuit board.
DIAG/TEMP PS The Power Supply (PS) temperature will be again displayed.
DIAG/TEMP TEMP Repeats that the display is in the TEMP sub-mode.
DIAG/TEMP 36C
Temperature display in Centigrade for Power Supply circuit board NOTE:
that the PS temperature has dropped one degree.
This display cycle repeats until the Display Mode Selector is pushed.
DIAGNOSTIC MODE Power Supply Voltage Status (POWER)
A quick push of the Display Mode Selector advances to the Power (POWR)
diagnostic sub-mode. The DIAG LED will glow Green when all power levels
are normal and Red when any power level is outside normal level.
DIAG/POWER POWR Indicates the display is in the POWER sub-mode.
DIAG/POWER BASE Indicates that the Base Station main controller board is being measured.
DIAG/POWER POWER Indicates the display is in the POWER sub-mode.
DIAG/POWER OK Indicates that the item is in an OK State.
DIAG/POWER DISP Indicates that the LED Display controller board is being measured.
DIAG/POWER POWER Indicates the display is in the POWER sub-mode.
DIAG/POWER OK Indicates that the item is in an OK State.
DIAG/POWER CHAR Indicates that the Four Character controller board is being measured.
DIAG/POWER POWR Indicates the display is in the POWER sub-mode.
DIAG/POWER OK Indicates that the item is in an OK State.
DIAG/POWER AUD Indicates that the Audio controller board is being measured.
DIAG/POWER POWR Indicates the display is in the POWER sub-mode.
DIAG/POWER OK Indicates that the item is in an OK State.
DIAG/POWER VBS Indicates that the VBS (analog Video) controller board is being measured.
DIAG/POWER POWR Indicates the display is in the POWER sub-mode.
DIAG/POWER OK Indicates that the item is in an OK State.
DIAG/POWER Exception
DIAG/POWER ERR
Instead of OK, the display will show ERR if a power level is outside of
normal – ERR is followed by a Hexadecimal code. Please note the error
code and contact support at Telecast-Fiber.