Telecast CH3-MPS-95VD-2ST-304, Руководство пользователя

Страница: 70 / 86

Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver System User Guide – 110124V4JH
Page 68
Display Mode Readout Base Station Digital Display Activity Explanation
DIAGNOSTIC MODE Microcontroller Board Revision Version (REV)
DIAG/REV
A quick push of the Display Mode Selector advances to the Power (POWR)
diagnostic sub-mode. This sub-mode displays the microcontroller firmware
revision of every board in the Base Station that has a microcontroller.
(Note: the REV versions noted here were current as of August 1, 2010. Your
system may have different REV versions)
DIAG/REV REV Initial display of REV after Display Mode Selector being advances.
DIAG/REV DISP Indicates the Display microcontroller board is revision is being queried.
DIAG/REV REV Indicates that sub-mode is REV.
DIAG/REV REVC Indicates that the REV for the DISP board is REVC.
DIAG/REV VBS Indicates the VBS microcontroller board is revision is being queried.
DIAG/REV REV Indicates that sub-mode is REV.
DIAG/REV REVA Indicates that the REV for the VBS board is REVA.
DIAG/REV BASE
Indicates the Base Station main microcontroller board is revision is being
queried.
DIAG/REV REV Indicates that sub-mode is REV.
DIAG/REV REVA Indicates that the REV for the BASE board is REVA.
DIAG/REV AUD Indicates the audio microcontroller board is revision is being queried.
DIAG/REV REV Indicates that sub-mode is REV.
DIAG/REV REVA Indicates that the REV for the AUD board is REVA.
DIAG/REV PS
Indicates the power supply microcontroller board is revision is being
queried.
DIAG/REV REV Indicates that sub-mode is REV.
DIAG/REV REVD Indicates that the REV for the DISP board is REVD.
This display cycle repeats until the Display Mode Selector is pushed.
DIAGNOSTIC MODE Camera Unit Error Status (CAM)
A quick push of the Display Mode Selector advances to the Camera Unit
(CAM) diagnostic sub-mode. This mode displays the status of the Camera
Unit. The DIAG LED glows green if Camera Unit shows no error and red if
the Camera Unit does have an error.
DIAG/CAM CAM Indicates that the sub-mode is CAM.
DIAG/CAM OK Indicates that the Camera Unit is reporting No fault.
DIAG/CAM ERR Indicates that the Camera Unit is reporting Some fault.
This display cycle repeats until the Display Mode Selector is pushed.