Telecast CH3-MPS-95VD-2ST-304, Руководство пользователя

Страница: 24 / 86

Telecast Fiber Systems – CopperHead FS790 ProHD Transceiver Sys CopperHead FS790 ProHD Transceiver System User Guide
Page 22
1) Identify three connectors
a.The white power connector
b.The black voltage data connector
c. The black unused connector (not connected to
the battery adaptor)
2) Pull the white power connector apart by pushing
the connector release tab
3) Slide the black voltage data connector apart
4) Once the two connectors are separated put the
camera to one side
1) Position the Camera Unit on the working surface
so that the connectors are positioned as shown
in the illustration
2) Identify the 4 screw holes as indicated
3) Position the Battery Mount so that you can
access the connectors in the Battery Mo
the Camera Unit
4) Connect (A) the White Power connector
5) Connect (B) the Power Voltage Data Connector
6) Position connector (C) inside the opening of the
Camera Unit to that it will not be pinched by the
Battery Mount when attached to the Camera
Unit. This connector is not used.
1) Carefully position the two connected wires
within the Camera Unit
2) Place the Battery Mount on to the Camera Unit
being careful not to pinch any of the wires
between the Battery Mount and the Camera
Unit
3) Line up the four screw holes
Battery Mount and the Camera Unit
4) Install the screws you removed in the previous
step
Note: For these steps the installation of the
IDX “V-Mount” battery adaptor is identical
tem User Guide – 110124V4JH
ltage data connector
The black unused connector (not connected to
Pull the white power connector apart by pushing
Slide the black voltage data connector apart
Once the two connectors are separated put the
Position the Camera Unit on the working surface
so that the connectors are positioned as shown
Identify the 4 screw holes as indicated
Position the Battery Mount so that you can
access the connectors in the Battery Mount and
Connect (A) the White Power connector
Connect (B) the Power Voltage Data Connector
Position connector (C) inside the opening of the
Camera Unit to that it will not be pinched by the
Battery Mount when attached to the Camera
his connector is not used.
Carefully position the two connected wires
Place the Battery Mount on to the Camera Unit
being careful not to pinch any of the wires
between the Battery Mount and the Camera
holes between the
Battery Mount and the Camera Unit
Install the screws you removed in the previous
Note: For these steps the installation of the
Mount” battery adaptor is identical