Operating Basics
Table 2-2: Mainframe GPI jumper settings on the A10 MAIN board
Jumper illustration
Jumper setting
Function
All of the jumpers short pins 1-2.
(factory default settings)
LAN (Ethernet)
All of the jumpers short pins 2-3.
GPI
6.
After you move the jumpers, replace the top cover on the instrument.
7.
Reinstall the screws securing the top cover to the instrument.
8.
Remove the protective backing from the GPI label provided with the
instrument, and then apply it to the rear panel. (See Figure 2-30.)
Figure 2-30: Applying the mainframe GPI label to the rear panel
Pin Assignments of the
10 BASE-T Connector
The following
fi
gure shows the pin assignments of the 10 BASE-T connector
when the mainframe GPI is enabled. Use pins 1, 2, and 3 to input signals for
recalling a preset. Use pin 4 to output an alarm signal. Frame ground is used
for the ground return. When using a shielded LAN cable (shielded twisted pair
cable), you can use the shield of the cable as ground.
2–34
TG700 TV Signal Generator Platform User Manual
Содержание TG700
