Tektronix TG700, Руководство пользователя

Страница: 57 / 343

Getting Started
19. Press the CANCEL button again to exit the Select Format submenu.
20. Disconnect the Black 2 signal from the module and the WFM7120.
21. Connect the Black 3 signal from the module to the reference input of the
WFM7120.
22. Set Black 3 to a PAL signal on the GPS7 module:
a. Use the right ( ► ) arrow button to select Black 3 .
b. Press the ENTER button.
c. Use the right ( ► ) arrow button to select PAL .
d. Press the ENTER button.
e. Use the left ( ◄ ) or right ( ► ) arrow button to select Black Burst .
f. Press the ENTER button.
g. Press the CANCEL button to exit the PAL submenu.
23. Check that the WFM7120 shows PAL on the reference input.
24. Use the left ( ◄ ) or right ( ► ) arrow button to select 1080 24p .
25. Press the ENTER button.
26. Check that the WFM7120 shows 1080 24p on the reference input.
27. Press the CANCEL button to exit the Select Formats menu.
Black output VITC.
1. Connect a cable from the Black 1 output on the module to the CMPST A input
on the WFM7120, and terminate the loop through with a 75
Ω terminator.
Activate the input by pressing the C input button on the front panel of the
monitor.
2. On the WFM7120, press the CONFIG button and select VITC as the timecode
source.
3. On the TG700, press the MODULE button until GPS7 appears.
4. Use the up ( ▲ ) or down ( ▼ ) arrow button to select SELECT OUTPUT .
5. Use the left ( ◄ ) or right ( ► ) arrow button to select Black 1 .
6. Press the ENTER button.
7. Use the up ( ▲ ) or down ( ▼ ) arrow button to SELECT FORMAT .
8. Use the left ( ◄ ) or right ( ► ) arrow button to select button to select NTSC .
9. Press the ENTER button.
10. Use the left ( ◄ ) or right ( ► ) arrow button to select Black Burst .
TG700 TV Signal Generator Platform User Manual 1–29