Getting Started
11.
Press the
ENTER
button.
12.
Press the
CANCEL
button to exit the NTSC submenu.
13.
Use the up (
▲
) or down (
▼
) arrow button to select
Timecode
.
14.
Press the
ENTER
button.
15.
Use the left (
◄
) or right (
►
) arrow button to select
Time of Day
as the
Timecode Source.
16.
Press the
ENTER
button.
17.
Use the up (
▲
) arrow to select the
VITC
submenu and press the
ENTER
button to select
VITC 1
.
18.
Press the right (
►
) arrow to select
Output : Enable
.
19.
Press the
ENTER
button.
20.
Use the down (
▼
) arrow to select
Line number
.
21.
Press the left (
◄
) arrow to select
Line number: 14
.
22.
Check that the time of day is correctly updating on the WFM7120 Timecode
display.
23.
Repeat the procedure for Black 2 and Black 3 signals.
LTC output.
1.
Connect the LTC/GPIO breakout adapter cable to the LTC/GPI DSUB on the
back of the GPS7 module.
2.
Construct an adapter by soldering wires between a female XLR and a 9-pin
DSUB male header with solder cups, with this pin out:
a.
XLR pin 1 to DSUB pin 1.
b.
XLR pin 2 to DSUB pin 2.
c.
XLR pin 3 to DSUB pin 3.
3.
Connect the LTC 1 output on the breakout cable to the XLR adapter you
just made.
4.
Connect the DSUB end of the adapter you just made to the remote connector
on the WFM7120.
5.
Con
fi
gure the WFM7120 to use LTC as the Timecode source.
1–30
TG700 TV Signal Generator Platform User Manual
Содержание TG700
