Tektronix TG700, Руководство пользователя

Страница: 61 / 343

Getting Started
Genlock.
1. Set the Reference Source to Internal.
a. Use the up ( ▲ ) or down ( ▼ ) arrow button to select REFERENCE .
b. Press the ENTER button.
c. If needed, use the up ( ▲ ) or down ( ▼ ) arrow button to select SOURCE .
d. Use the left ( ◄ ) or right ( ► ) arrow button to select Internal .
2. Check that the INT.REF indicator at the right side of the front panel lights.
This shows that the instrument is using the internal reference signal.
3. Use the left ( ◄ ) or right ( ► ) arrow button to select NTSC Burst .
4. Press the ENTER button.
5. Check that the INT.REF indicator is not lit and the EXT.REF indicator is
fl ashing. This shows that the is not locked to any reference signal.
6. Press the CANCEL button to exit the Reference Source menu.
7. Connect the NTSC signal generator output to the BLACK 1 / REF IN
connector using a 75 Ω BNC cable.
8. Set the NTSC signal generator to output an NTSC signal.
9. Check that the EXT.REF indicator lights. This shows that the instrument is
using the external reference signal.
10. Disconnect the test setup.
HD3G7 Module Functional
Check
Use the following procedure to check that the HD3G7 HD 3 Gb/s SDI Video
Generator module is functional.
Required Equipment.
HD-SDI video signal generator
3 Gb/s waveform monitor
Two 1 m (3 ft) BNC to BNC high-bandwidth cables
Procedure.
1. Install the module into the TG700 mainframe. (See page 1-9.)
2. Power on the TG700 mainframe by connecting it to the power source. The
initialization of all the installed modules is executed.
3. Check that no error messages appear on the LCD display.
TG700 TV Signal Generator Platform User Manual 1–33