TAKASAGO HX-S-01000-12G2, Инструкция по эксплуатации

Страница: 186 / 240

Calibration
186
Output Current Control with External Resistance (B)
1. Perform load with only the shunt resistor.
Disconnect the load wires and the remote sensing
wires.
Connect the shunt to the output terminal. Connect
the digital multimeter to the terminal located on the
shunt.
Turn the POWER switch ON and OUTPUT OFF in
advance.
Note: Large current flows through
the wiring material.
Use wires which will not produce
a voltage drop below 0.8V.
Calibration Circuit
Power Supply
+
-
+ -
V
6
19
External
Control Connector
External
Resistance
0 to 10k
Ω
2. Set the constant voltage setting value to [ xV ]
and the external resistance to 0Ω and set the
output to ON.
30-200 30-400 60-100 60-200
[xV] 1.00V 1.00V 1.00V 1.00V
500-12 500-24 1000-6 1000-12
[xV] 1.0V 1.0V 1V 1V
120-50 120-100 400-15 400-30
[xV] 1.0V 1.0V 1.0V 1.0V
For how to set, refer to Output Current Control with
External Resistance (B).(page
153)
3. Press the FUNC. key.
4. Turn the VOLTAGE dial to display the setting item
number 30 in the Number Display (voltage).
* At that time, turn off the Number Display (current).
5. Adjust so that the output current becomes "0A"
with the CURRENT dial.
6. Press the FUNC. key to settle the offset calibration
value of output current control with external
resistance (B).