TAKASAGO HX-S-01000-12G2, Инструкция по эксплуатации

Страница: 176 / 240

Calibration
176
Output Voltage Control with External Resistance(A)
1. Disconnect the load wires and the remote
sensing wires. Connect the digital multimeter to
the output terminal.
Turn the POWER switch ON and OUTPUT OFF in
advance.
Power Supply
+
-
V
+
-
Digital
Multimeter
Calibration Circuit
7
20
External
Control Connector
External Resistance
0
to ∞Ω
2. Set the external resistance to infinity (open) and
the constant current setting value to [ yA ] and
set the output to ON.
30-200 30-400 60-100 60-200
[yA] 1.0A 1.0A 1.0A 1.0A
500-12 500-24 1000-6 1000-12
[yA] 0.10A 0.10A 0.010A 0.10A
120-50 120-100 400-15 400-30
[yA] 0.10A 1.0A 0.10A 0.10A
On how to set, refer to Output Voltage Control (A)
with External Resistance.(page145)
3. Press the FUNC. key.
4. Turn the VOLTAGE dial to display the setting item
number 28 in the Number Display (voltage).
* At that time, turn off the Number Display (current).
5. Adjust so that the output voltage becomes "0.000V"
with the CURRENT dial.
6. Press the FUNC. key to settle the offset calibration
value of output voltage control with external
resistance (A).