TAKASAGO HX-S-01000-12G2, Инструкция по эксплуатации

Страница: 145 / 240

Controlling with External Analog & Contact Signals
145
Output Voltage Control
Output Voltage Control with External Resistance
1. Output Voltage Control with External Resistance (A)
*This function can not use 1000V type.
This section describes how to set the output voltage zero when the
external resistance value is infinity.
The output voltage is derived from the following formula.
Output Voltage [V]
=
10 ] [ Resistance External
10
] [ Voltage Output Maximum


ｋΩ
Ｖ
The output accuracy for the external resistance, is the set voltage ±
(0.2% of Rated Output Voltage) when 10kΩ.
Connection
Connect the resistor between No. 7 and 20 of the external control connector (accessory).
Setting Procedures
Set the parameter to 2 (External Resistance Type A) according to the procedure on page146.
7
20
Output Voltage Control with External Resistance(A)
External Resistance
0～∞Ω
External Control Connector
Twisted-Pair Wire

Isolation for the wire connecting to the external control should be more than the relative ground voltage
of this product.
Otherwise, the user may receive electric shock.

The External Resistance A, B, and C and the External Voltage cannot be used together to control the
output.
！
CAUTION
MAX
∞
0
External
Resistance
O
u
tp
u
t V
o
lta
g
e
CV_RA
10k
Ω
MAX
１
2