SV 258 PRO (AG) User Manual
30
“Internal memory”
icon is displayed
when internal memory is assigned for
file saving.
“note”
icon is displayed when the wave
recording is active.
Icons connected with modem functionality:
or
“no wireless”
icon is displayed when
the
GPRS
function is switched on and
there is no cable connection with the
modem
or
“no range”
icon is displayed when the
GPRS function is switched on and there is
no cable connection with the modem and
therefore no range
or
“wireless”
icon is displayed when the
wireless transmission (
GPRS
modem) is
active, but there is no connection with
Host or SvanNET
or
“no range”
icon is displayed when the
wireless transmission (
GPRS
modem) is
active, but the modem is out of range
or
“host”
icon is displayed if there is
connection with Host
“range”
icon is displayed if there is GPRS
connection and shows the level of the
GPRS
signal
and
ways
of
data
transmission.
“SvanNET”
icon is displayed if there is
connection with SvanNET.
4.2.5 Data saving
Memory type
All available measurement results and settings can be stored in the instrument’s internal memory as files. There
are three types of files that instrument generates and saves in the internal memory: files with results records (so
called logger files), files with wave signal records (so called wave files) and files with settings (so called setup
files). The memory is divided into to two partitions: one partition is reserved for the wave and setup files, another
– for the logger files.
Saving files with measurement results
Logger and wave files are created automatically when the measurement starts and saved after the measurement
stops.
Logger files are always created and saved, but you can switch off wave files creation.
Note: During the measurement run
the “curve” icon is displayed. During the wave signal recording
the “note” icon is displayed.
Files are saved with names which you can define. If the file mane was not defined the instrument will give the
name to the new automatically created file based on the rule: new file name will be created on the base of
previously saved file name but it’s number will be increased by one. In this case, number is a string of digits in
the end of the name. If the file hasn’t a string of digits the instrument will add “0” in the end of the new file name.
The logger file name (with extension
SVL
), which has been created after the
measurement start is displayed in the left upper part of the screen, below the
icon line.
As you can see, the number of the file at the presented screen is 1 (
L1.SVL
).
After starting new measurement with the
<Start/Stop>
key new file name will
automatically change its number on 2 (
L2.SVL
).
