Suzuki VLR1800, Руководство по обслуживанию

Страница: 317 / 624

Engine Lubrication System: 1E-5
• Install the oil strainer (4).
NOTE
When installing the oil strainer (4), fit the
convex part “C” of the oil strainer into the
hole “D” of the crankcase.
• Apply bond to the mating surface of the oil pan.
NOTE
Use of SUZUKI BOND is as follows:
• Make surfaces free from moisture, oil, dust
and other foreign materials.
• Spread the sealant on surfaces thinly to
from an even layer, and assemble the oil
pan within a few minutes.
• Apply to distorted surfaces as it forms a
comparatively thick film.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
• Tighten the oil pan bolts diagonally.
NOTE
• Fit the new gasket washers to the oil pan
bolts “A”.
• Fit the clamp “B” and stay “C” to the bolts.
CAUTION
!
Use a new gasket washer to prevent oil
leakage.
• After installing the removed parts, pour engine oil and
engine coolant. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-11)” and
“Cooling System Inspection in Section 0B (Page 0B-
15)”.
Oil Pressure Regulator / Oil Strainer Inspection
B822H11506004
Refer to “Oil Pan / Oil Strainer / Oil Pressure Regulator
Removal and Installation (Page 1E-3)”.
Oil pressure regulator
Inspect the operation of the oil pressure regulator by
pushing on the piston with a proper bar.
If the piston does not operate, replace the oil pressure
regulator with a new one.
Oil Strainer
Clean the oil strainer, if necessary.
Inspect the oil strainer body for damage. If necessary,
replace it with a new one.
4
“C”
“D”
I822H1150012-02
I822H1150040-02
“A”
“A”
“B”
“B”
“B”
“C”
I822H1150013-02
I822H1150014-01
I822H1150015-01