Suzuki VLR1800, Руководство по обслуживанию

Страница: 203 / 624

Engine Electrical Devices: 1C-2
IAP Sensor Removal and Installation
B822H11306005
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-8)”.
2) Disconnect the IAP sensor (front and rear) couplers
(1) and IAP sensors (2) (front and rear) from the air
cleaner chamber.
3) Remove the vacuum hoses (3).
Installation
Install the IAP sensors in the reverse order of removal.
TP Sensor Inspection
B822H11306006
Refer to “DTC “C14” (P0120-H/L): TP Sensor Circuit
Malfunction in Section 1A (Page 1A-38)”.
TP Sensor Removal and Installation
B822H11306007
Refer to “Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-12)”.
TP Sensor Adjustment
B822H11306025
Inspect the TP sensor setting position and adjust it if
necessary in the following procedures:
1) Connect the special tool (Mode select switch) to the
dealer mode coupler. Refer to “Self-Diagnostic
Procedures in Section 1A (Page 1A-12)”.
Special tool
: 09930–82720 (Mode select switch)
2) Remove the right air cleaner box. Refer to “Air
Cleaner Element Removal and Installation in Section
1D (Page 1D-6)”.
3) Warn up the engine and keep it running in idling
speed.
4) Turn the mode select switch ON.
5) Check the position of the bar in the left of C code
displayed on the LCD panel.
6) Loosen the TP sensor mounting screw using the
special tool and turn the TP sensor to bring the bar
to the correct position.
Special tool
: 09930–11950 (Torx wrench)
7) Tighten the TP sensor mounting screw to the
specified torque.
Tightening torque
TP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lb-ft)
8) Turn off the engine and install the right air cleaner
box. Refer to “Air Cleaner Element Removal and
Installation in Section 1D (Page 1D-6)”.
1
1
2
2
I822H1130003-01
3
3
I822H1130004-01
“A”: Incorrect position “B”: Correct position
“B”
“A”
“A”
I823H1130022-01
I822H1130021-01