Suzuki VLR1800, Руководство по обслуживанию

Страница: 297 / 624

Engine Mechanical: 1D-86
Conrod / Crankshaft Inspection
B822H11406055
Refer to “Conrod Removal and Installation (Page 1D-
84)”.
Conrod Small End I.D.
Measure the conrod small end inside diameter using the
small bore gauge.
If the conrod small end inside diameter exceeds the
service limit, replace the conrod.
Special tool
(A): 09900–20602 (Dial gauge (1/1000 mm, 1
mm))
(B): 09900–22403 (Small bore gauge (18 – 35
mm))
Conrod small end I.D.
Service limit: 23.040 mm (0.9071 in)
Conrod Big End Side Clearance
1) Check the conrod big end side clearance using the
thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
Conrod big end side clearance
Service limit: 0.30 mm (0.012 in)
2) If the clearance exceeds the limit, remove the conrod
and measure the conrod big end width and crank pin
width. Refer to “Conrod Removal and Installation
(Page 1D-84)”. If the width exceed the limit, replace
the conrod or crankshaft.
Special tool
(B): 09900–20205 (Micrometer (0 – 25 mm))
(C): 09900–20605 (Dial calipers (1/100 mm,
10 – 34 mm))
Conrod big end width
Standard: 23.95 – 24.00 mm (0.943 – 0.945 in)
Crank pin width
Standard: 24.10 – 24.15 mm (0.949 – 0.951 in)
Conrod Crank Pin Bearing Inspection and
Selection
B822H11406028
Refer to “Conrod Removal and Installation (Page 1D-
84)”.
Inspection
1) Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
2) Place the plastigauge axially along the crank pin,
avoiding the oil hole, as shown.
Special tool
(A): 09900–22301 (Plastigauge (0.025 –
0.076 mm))
(B)
(A)
I822H1140361-01
(A)
I822H1140291-01
(C)
(B)
I822H1140292-01
I718H1140285-01
(A)
(A)
I822H1140293-01