Suzuki VLR1800, Руководство по обслуживанию

Страница: 372 / 624

1I-5 Starting System:
Starter Motor Disassembly and Assembly
B822H11906003
Refer to “Starter Motor Removal and Installation
(Page 1I-4)”.
Disassembly
Disassemble the starter motor as shown in the starter
motor components diagram. Refer to “Starter Motor
Components (Page 1I-3)”.
Assembly
Reassemble the starter motor in the reverse order of
removal. Pay attention to the following points:
CAUTION
!
Replace the O-rings with new ones to prevent
oil leakage and moisture.
• Apply grease to the lip of the oil seal and bearing.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply a small quantity of moly paste to the armature
shaft.
: Moly paste 99000–25140 (SUZUKI Moly
paste or equivalent)
• Align the projection “A” on the brush holder with the
groove “B” on the starter motor case.
• Tighten the brush holder nut (1) to the specified
torque.
Tightening torque
Brush holder nut (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Align the projection “C” on the brush holder with the
groove “D” on the housing end.
• Align the match mark on the starter motor case with
the match mark on the housing end.
• Tighten the starter motor housing bolts (2).
Tightening torque
Starter motor housing bolt (b): 5 N·m (0.5 kgf-m,
3.5 lb-ft)
I822H1190008-02
I822H1190009-01
“A”
“B”
I822H1190010-01
(a)
1
“C”
“D”
I822H1190011-01
(b)
2
I822H1190012-01