S CLASS™ 2 cutter
User’s Manual
Contour Cutting
3-3
3.2.2
OPOS XY
A function is available in OPOS to compensate curved printing errors in the Y-axis also. This
function is called OPOS XY. An extra line needs to be printed with the design to be able to
use the OPOS XY functionality.
The OPOS sensor will measure points along the extra line when OPOS XY is enabled. The
number of measuring points will be determined by the cutter and will depend on the width
of the design.
NOTE:
The default setting for OPOS is OPOS X. If the OPOS XY functionality is
needed, then the user must change the setting ‘alignment mode’ in the OPOS
Setup to OPOS XY manually on the control panel or via the cutting software.
NOTE:
Some cutting software do not support the OPOS XY feature. If they also
send the alignment command ‘OPOS’ to the cutter, then they block the cutter’s
OPOS XY feature. If it is possible to define a line manually in the design, so that it
meets up to the specifications above, the blocking of the software can be
neutralized by using the setting: ‘FORCE OPOS XY’ in the alignment mode.
The line can be added between or above the front Y marks. The distance between the
center of the marks and the line should not be more than 20mm( distance 1). The left and
right margin between the line and the mark should be 10mm for optimal sensing (distance
2). The line itself should be 3mm thick. There should be at least 5mm white space above the
line.
Содержание S Class 2 OPOS-CAM
Страница 1: ...User s Manual Rev 3b...
