Subaru WRX-STI, Руководство пользователя

Страница: 353 / 578

Black plate (365,1)
一 般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
.
When starting the engine, be sure
to sit in the driver
’
s seat.
NOTE
.
Avoid rapid racing and rapid accel-
eration immediately after the engine
has started.
.
For a short time after the engine has
started, the engine speed is kept high.
When the warm-up is completed, the
engine speed lowers automatically.
.
On rare occasions, it may be difficult
to start the engine depending on the
fuel and the usage condition (repeated
driving of a distance in which the
engine has not warmed up sufficiently).
In such a case, it is recommended that
you change to a different brand of fuel.
.
On rare occasions, transient knock-
ing may be heard from the engine when
the accelerator is operated rapidly
such as a rapid start-up and a rapid
acceleration. This is not a malfunction.
.
The engine starts more easily when
the headlights, air conditioner and rear
window defogger are turned off.
&
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 sec-
onds. If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been discon-
nected and reconnected (for mainte-
nance or other purposes). This diffi-
culty is caused by the electronically
controlled throttle
’
s self-diagnosis
function. To overcome it, keep the
ignition switch in the
“
ON
”
position
for approximately 10 seconds before
starting the engine.
!
MT models
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
The starter motor will only operate when
the clutch pedal is depressed fully to the
floor.
4. Turn the ignition switch to the
“
ON
”
position and check the operation of the
warning and indicator lights. Refer to
“
Warning and indicator lights
” F
3-14.
5. Turn the ignition switch to the
“
START
”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the engine does not start, try the
following procedure.
(1) Turn the ignition switch to the
“
LOCK
”
position and wait for at least
10 seconds. After checking that the
parking brake is firmly set, turn the
ignition switch to the
“
START
”
position
while depressing the accelerator pedal
slightly (approximately a quarter of the
full stroke). Release the accelerator
pedal as soon as the engine starts.
(2) If this fails to start the engine, turn
the ignition switch back to the
“
LOCK
”
position and wait for at least 10
seconds. Then fully depress the accel-
erator pedal and turn the ignition
switch to the
“
START
”
position. If the
engine starts, quickly release the
accelerator pedal.
(3) If this fails to start the engine, turn
Starting and operating/Starting and stopping engine (models without push
–
button start system)
7-7
–
CONTINUED
–
7