Black plate (116,1)
一
般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
2-16
Keys and doors/Keyless access with push
–
button start system
!
By operating the driver
’
s door
1. Sit in the driver
’
s seat, and close the
door.
2. Push the rear side (unlock side) of the
power door locking switch.
3. Within 5 seconds after step 2 is
performed, open the driver
’
s door.
4. Within 5 seconds after step 3 is
performed, push the rear side (unlock
side) of the power door locking switch
twice while the door is open.
5. Within 10 seconds after step 4 is
performed, close and open the driver
’
s
door twice.
6. Within 10 seconds after step 5 is
performed, push the rear side (unlock
side) of the power door locking switch
twice while the door is open.
7. Within 10 seconds after step 6 is
performed, close and open the driver
’
s
door once.
8. Within 5 seconds after step 7 is
performed, close the door. A chirp sound
will be heard for 2 seconds, and the
functions will be disabled.
NOTE
In steps 4 and 6, press the power door
locking switch slowly. If the switch is
pressed quickly, the functions may not
be disabled.
!
Enabling functions
When the procedure to disable the func-
tions is performed again, a chirp sound will
be heard, and the functions will be
enabled.
NOTE
.
The keyless access function will be
enabled only if you perform the proce-
dure in the same manner you disabled
the function (for example, when dis-
abling by operating the driver
’
s door,
the function will not be enabled even if
you operate the access key).
.
Press the push-button ignition
switch if you do not know the proce-
dure in which the keyless access
function was disabled.
–
When disabling by operating the
driver
’
s door: a chirp will not be
heard
–
When disabling by operating the
access key: a chirp will be heard
&
When access key does not
operate properly
Refer to
“
&
Replacing battery of access
key
Refer to
“
Replacing battery of access key
&
Technical information for
Europe models
.
This device complies with the essential
requirements of the Radio and Telecom-
munications Terminal Equipment Directive
1999/5/EC. A copy of the original Declara-
tion of Conformity and the CE marking are
found in chapter 13.
.
Hereby, DENSO CORPORATION de-
clares that this 13CZY/14AHB is in com-
pliance with the essential requirements
and other relevant provisions of Directive
1999/5/EC.