Black plate (37,1)
一
般
Model "A1270GE-A" EDITED: 2016/ 3/ 10
NOTE
.
If a new position is registered for the
same button, the previously registered
seat position is deleted.
.
If the vehicle battery is removed, the
registered seat position is not deleted.
.
When the button
“
1
”
or
“
2
”
is
pressed within 45 seconds after the
driver
’
s door is opened, the registered
seat position can be retrieved even if
the ignition switch is in the
“
LOCK
”
or
“
OFF
”
position.
!
Retrieval of the seat position
registered with access key (if
equipped)
1. Hold the registered access key.
2. Unlock the driver
’
s door by pressing
the
“ ”
button or gripping the door handle.
3. Open the driver
’
s door.
A chirp sounds and the seat moves to the
registered position.
When the seat moves to the registered
position, a chirp will sound.
NOTE
.
If the registered seat position cannot
be retrieved after performing the pre-
vious procedures, try the following
procedures.
(1) Press the
“
SET
”
button on the
driver
’
s door.
(2) Press the
“ ”
button on the
access key or the door lock button
to lock the doors.
(3) Perform the prior procedures
again.
.
If the keyless access function is
disabled, the seat position cannot be
retrieved by gripping the driver
’
s door
handle. However, the seat position can
still be retrieved by pressing the
“ ”
button on the access key. For informa-
tion about how to enable/disable the
keyless access function, refer to
abling keyless access function
.
If a new position is registered for the
same access key, the previously regis-
tered seat position is deleted.
!
Clearing the registered seat
position with access key (if
equipped)
1. Close the driver
’
s door.
2. While holding the access key and
pressing the
“
SET
”
button, press the
“ ”
button on the access key.
A chirp will sound, and the registered seat
position will be cleared.
&
Head restraint adjustment
WARNING
.
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear. Also, never install
the head restraints the opposite
way round. Doing so will prevent
the head restraints from func-
tioning as intended. Therefore,
when you remove the head re-
straints, you must reinstall all
head restraints correctly to pro-
tect vehicle occupants.
.
All occupants, including the dri-
ver, should not operate a vehicle
or sit in a vehicle
’
s seat until the
head restraints are placed in their
Seat, seatbelt and SRS airbags/Front seats
1-7
–
CONTINUED
–
1