Steca coolcept StecaGrid 1500, Инструкция по установке и эксплуатации

Страница: 23 / 94

3.6.2 Network (TCP/IP)
The device can transfer yield data and event messages via the TCP/IP
interface to the Internet portal http://www.solare-energiewende.de
server. The yield data can be displayed graphically in the Internet
portal as illustrated below. This service is free of charge for a period
of 2 years from the time of registration. The following applies:
n
Before the Internet portal can be used, the user must go to
www.steca.com/portal to register. See more
Ä
Chapter 5.4
‘Internet portal’ on page 53
n
The local network settings must be set at the inverter in order to
establish a connection to the Internet portal server. This can be
performed automatically or manually:
Automatically: If IP addresses are automatically assigned in
your network (DHCP), then no settings need to be made at the
inverter.
Manually: If IP addresses are not automatically assigned in your
network, then you must manually set the inverter network
settings via
Settings
▶
Network
; see Ä ‘TCP/IP network’
on page 18
n
The address of the Internet portal server is permanently stored
in the inverter and cannot be changed.
n
Once the network connection is established, the inverter
automatically starts non-encrypted transmission of data to the
server.
Notice
The network cable must be disconnected in order to
prevent transmission of the data, or data transmission
must be disabled according to Ä ‘TCP/IP network’
on page 18.
Fig. 4: Graphical representation of the yield data in the Internet
portal
EN
747,431 | Z09.2 | 18/02/2016 23