SSINVERTER SSI700, Руководство пользователя, Страница: 49 / 148

SSI700 User Manual Function Code
www.ssinverter.info
Property
Default Setting Range Parameter Name
Function
Code
Group P4: Input Terminals
☆ 000
Unit's digit (Setting for AI1 less
than minimum input)
Setting for AI less than
minimum input
P4-34
0: Minimum value
1: 0.0%
Ten's digit (Setting for AI2 less
than minimum input)
0, 1 (same as AI1)
★
0.0s
0.0–3600.0s
DI1 delay time P4-35
★ 0.0s
0.0–3600.0s
DI2 delay time P4-36
★
00000
Unit's digit (DI1 valid mode)
DI valid mode
selection1
P4-38
0: High level valid
1: Low level valid
Ten's digit (DI2 valid mode)
0, 1 (same as DI1)
Hundred's digit (DI3 valid mode)
0, 1 (same as DI1)
Thousand's digit(DI4 valid mode)
0, 1 (same as DI1)
Ten thousand's digit(DI5 valid
mode)
0, 1 (same as DI1)
Property
Default Setting Range Parameter Name
Function
Code
Group P5: Output Terminals
☆
0
0: Pulse output (FMP)
1: Switch signal output (FMR) FM terminal output
mode
P5-00
☆
0
0: No output
1: AC drive running
2: Fault output (stop)
3: Frequency-level detection
BRAKE control 1 output
4: Frequency reached
5: Zero-speed running (no output
at stop)
6: Motor overload pre-warning
7: AC drive overload pre-warning
8: Set count value reached
9: Designated count value
reached
10: Length reached
11: PLC cycle complete
12: Accumulative running time
reached
13: Frequency limited
14: Torque limited
15: Ready for RUN
16: AI1 larger than AI2(AI1>AI2)
17: Frequency upper limit
reached
18: Frequency lower limit
reached (no output at stop)
19: Undervoltage state output
20: Communication setting
21: Complete orientation
22: Location close to
23: Zero-speed running 2
(having output at stop) FMR function
(opencollector
output terminal)
P5-01
☆
2
Relay function (T/A-T/B-
T/C)
P5-02
-
- Reserved P5-03
☆
4
DO1 function selection
(open-collector output
terminal)
P5-04