44
Projector
Ch
apt
er 1 U
s
e
r G
u
id
e
Verify Current/Target Function
MAKE SURE THAT THE CORRECT (TARGET)
FUNCTION, e.g., F2 2D Flat, APPEARS IN “Current
Function” BEFORE MAKING ANY ADJUSTMENT ON
THIS SCREEN.
Once changes are saved to the Current Function
THERE
IS NO “UNDO”
and the changes you have made will
affect the presentation every time the FUNCTION is
recalled using either the Projector control screen or when
the FUNCTION is associated with a CPL as part of a Show
or SPL.
To change the Current Function refer to
Projector Function” on page 42
. The Current Function
indicates the FUNCTION selected either manually or by
CPL to FUNCTION association.
When a FUNCTION is selected on the PROJECTOR
CONTROL pane it may take some seconds to complete the
process as some adjustments are mechanical in nature, e.g.,
Zoom, Focus, etc. During this time the auditorium screen
may be dark.
If you make changes to settings and prior to saving the
changes exit the FUNCTION SET-UP screen the changes
will be discarded. However, the changed settings on the
projector remain until a new FUCNTION is selected.
While adjustments will immediately affect the projector
operation they are temporary and, unless Saved, will be
lost when another FUNCTION is selected.
Adjust Lamp Power
Screen Luminance vs. Lamp Power
Lamp Power Raise/Lower is used to adjust the bulb
brightness and therefore the screen luminance. The Lamp
Power indicator displays a value that is linked to the
Maximum and Minimum Lamp Power parameters (%)
included in the Serial Code.
To adjust LAMP POWER, tap
Menu
, tap
Projector
, tap
Function Setup
, and then either tap, or press and hold, the
LEFT ARROW
(Lower) or
RIGHT ARROW
(Raise)
while viewing the projected image on the screen.
Lamp Power changes are made in increments of 1%. The
Indicator shows the current Lamp Power setting.
To save the adjusted Lamp Power in the Current Function,
tap
Save to FUNCTION
.
Once changes are saved to the Current Function
THERE
IS NO “UNDO”
and the changes you have made will
affect the presentation every time the indicated
FUNCTION is recalled using either the Projector control
screen or when the FUNCTION is associated with a CPL
as part of a Show or SPL. This is especially significant for
Lamp Power because the bulb brightness, i.e., screen
luminance value stored in the Current Function may have
been set to a standard value, e.g., 14 ft-L using a
luminance measurement device.
If you make changes to settings and, prior to saving the
changes, exit the FUNCTION SET-UP screen the changes
will be discarded. However, the settings will be retained on
the projector until a new FUCNTION is selected.
Adjust Projector
Controls in this group are unavailable when Projection
Type is set to “Single 3D”.
When you configure the Projector for an aspect ratio, e.g.,
2.39:1 (CinemaScope
®
), 1.85:1 (VistaVision
®
) or
1.33:1 (Academy), the SRX-R320 sets the lens zoom to a
defined point so the larger of the image dimension fills the
screen. During projector installation the lens zoom setting
is adjusted using internal Projector Test Patterns or a
standard test DCP. Zoom positions for common aspect
ratios would be stored in selected FUNCTIONS
1
using the
Note
Note
Save to FUNCTION
Current Function
Caution
Note
1.A number of projector settings are stored including the
lamp brightness/luminance value so image brightness can
be maintained regardless of aspect ratio.
LAMP POWER
Raise
Lower
Save to FUNCTION
