52
Status
Ch
apt
er 1 U
s
e
r G
u
id
e
• IP Address
To set a static IP address, tap
IP Address
and the
Enter Address popup appears.
To set a new IP address, tap
CLEAR
, set the new IP
address by tapping the numbers on the
Keypad
, and
then tap
Accept
.
Entering the IP addresses from the ENTER
ADDRESS popup uses the “dotted decimal” format
and must include the “dot(s)” as part of the entry.
After IP address entry is complete, tap Save Settings as
required.
Status
You can view various status indicators for the Auditorium
Unit from the Projectionist Terminal.
The Status menu
selection allows you to
access the following
status information for the
following areas and
subsystems in the
Auditorium Unit.
• Projector
• Lamp
• Fan
• Temperature
• Media Block
• RAID
Additional information
may be contained in documentation specific to the various
sub-system.
To view the status information, tap Menu and then tap the
specific sub-system from the available Status Menus. The
Status panes present views into the selected sub-system.
Indicators found on the Status panes have three possible
states. They are:
(Green) - Operation Normal
(Yellow) - Warning
(Red) - Error
(Gray) - State Unknown
The Status section describes information available when a
specific Status Menu is selected. Refer to the specific
Menu section for additional details.
Note
IP ADDRESS
Assignment
Current
IP address
Enter
CLEAR
(Clr)
Keypad
“dot”
Tap Menu
Tap Status
Status Menu
